Face Shield Mechanism - BRP Ski-Doo OXYGEN User Manual

B. THE HELMET

10. FACE SHIELD MECHANISM

REMOVING / REPLACING THE FACE SHIELD MECHANISM
1 1 1 1 . . . . Remove the face shield as described in
the "6. FACE SHIELD" section of this
manual.
2 2 2 2 . . . . Use a Phillips #1 screwdriver to remove
the three screws (1), (2) and (3).
3 3 3 3 . . . . Grab the mechanism and lift it gently.
NOT NOTICE NOT NOT ICE ICE ICE
If the wires are stuck into the shell, do not
pull the mechanism, you could damage
them. Grab the wires and try to pull them
gently out of the shell.
4. 4. 4. 4. Once you have access to the screw,
use a Phillips #00 screwdriver to
disconnect the mechanism from the
helmet circuit.
NOTICE NOTICE NOTICE NOTICE
Do not pull directly on the electrical wires,
you could damage them.
5 5 5 5 . . . . Take a new mechanism and connect the
electrical wire as shown, by tightening the
screw to 0.3 Nm.
Make sure there is no free play in the
connection once the screw is fully
tightened.
6 6 6 6 . . . . Put back gently the wire into the helmet.
Once the wire is almost entirely inside the
helmet, position the mechanism and put
back the three screws. Tighten them to
0.4 Nm.
NOTICE NOTICE NOTICE NOTICE
Do not pinch the wire between the
mechanism and the
Do not overtighten the screws, you could
damage them.
7 7 7 7 . . . . Repeat steps 2 – 6 for the other side.
8 8 8 8 . . . . Put back the face shield as described in the "6. FACE SHIELD" section of
this manual.
9 9 9 9 . . . . Connect your helmet to your vehicle for a quick functional test, to make
sure everything is working properly.
shell.
12