Led Utility Light Installation - BRP Ski-Doo OXYGEN User Manual

H. ACCESSORIES AND SPARE PARTS

3. LED UTILITY LIGHT INSTALLATION

ST ST ST STEP 1 EP 1 EP 1 EP 1
Picture 1: Picture 1: Picture 1: Remove the neck protector. Start by removing the plastic tab on Picture 1:
each side to remove the entire rear portion.
Picture 2: Remove the chin part by pulling the front portion of the neck Picture 2: Picture 2: Picture 2:
protector toward the inner side of the helmet (as shown above).
Picture 3: Picture 3: Picture 3: Picture 3: Using a Phillips n°1 cruciform screw driver, remove the 2 screws.
STEP 2 STEP 2
STEP 2 STEP 2
Once the 2 screws have been removed, grab the part as shown above, and
pull it to tilt it backward.
Once you can see entirely the bottom of the part, you can remove it
completely.
STEP 3 STEP 3
STEP 3 STEP 3
Install the accessory light by positioning the upper corners first, then tilt it
forward to put it in position.
Note: : : : You should not have to force to tilt the light in position. If you do, it is Note Note Note
because something is wrong, and the corners of the lights have not been
positioned correctly.
STEP 4 STEP 4
STEP 4 STEP 4
Once the accessory light in position, make sure it is in the right position by
checking if the lens is perfectly located inside the aperture made for this.
If it is not in position, adjust it.
STEP 5 STEP 5
STEP 5 STEP 5
Put back the 2 screws to secure the accessory light in position (0.3 Nm).
Reinstall the neck protector, starting by the chin portion.
29