Magnetic Connector - BRP Ski-Doo OXYGEN User Manual

B. THE HELMET
INSTALLING THE SUN VISOR
1. 1. 1. 1. Make sure the sun visor mechanism is
in low position. (Sun visor lever up)
2. 2. 2. 2. Insert the sun visor between helmet
inner and outer shell and fit it on to the
locating pegs on both sides.
Then, press firmly towards the inside of
the helmet until the fork's inner insert is
completely inserted.
3. 3. 3. 3. Check that the sun visor mechanism is
functioning correctly.

8. MAGNETIC CONNECTOR

1. 1. 1. 1. Make sure your magnetic connector
and your helmet power outlet are clean.
2. 2. 2. 2. Plug the ELINQ connector directly
into the power outlet of your OXYGEN
helmet.
The power outlet and ELINQ connector
might become warm during normal
use.
NOTICE NOTICE NOTICE NOTICE
Do not pull directly on the cord to remove the ELINQ connector from your
helmet.
10