Table of Contents
Advertisement
F. CARE AND MAINTENANCE
Never use petroleum-based chemicals, solvents, gasoline, cleaning
agents or adhesives to clean the shell, liners or visors of your helmet.
Your helmet shell, liner and visors may be seriously damaged by the use
of such products and the full safety function of the helmet can then no
longer be guaranteed.
1. SHELL CLEANING
To clean the helmet shell, you can use water, soap or one of the
commonly available motorcycle shampoos, cleaners, polishes, plastic
cleaners or cleaning fluids.
Using water and soap is usually sufficient. Make sure when using the
other cleaning materials that these do not come into contact with the face
shield, since they can cause damage to the visor and its coating.
2. INTERIOR CLEANING
The inner lining of the ADVEX helmet can be removed completely.
The head and cheek pads can be washed by hand using a mild soap
solution (e.g. with highly diluted standard mild detergent) at a maximum
temperature of 30 °C.
Hand washing is recommended, but machine washing is also permitted.
Use the "delicate" cycle to prevent the agitator from damaging the sweat-
wicking material covering the liner parts. Allow the lining to dry at room
temperature and with good ventilation.
Do not place lining parts in the dryer: Excess heat may damage the foam
and coverings.
WARNING
WARNING
3. OUTER SURFACE OF THE FACE SHIELD
The helmet's shields are specially treated on both sides with an ANTI-
FOG or ANTI-SCRATCH coating.
Always use warm soapy water to clean the shields
Always use a soft clean cloth to wipe the shields and avoid scratching the
surface.
Never use petroleum based chemicals, solvent, gasoline, cleaning agent
or adhesives to clean the shields
4. HEATING LENS
The inside surface of the face shield must only be cleaned with a soft
cloth, which may be slightly dampened if required (we recommend a
microfiber cloth).
Do not use any cleaning agents.
WARNING
23
Advertisement
Table of Contents
