Protective Collar - BRP Ski-Doo OXYGEN User Manual

B. THE HELMET

4. PROTECTIVE COLLAR

The protective collar reduces air intrusion and unpleasant effect of the wind
created when you ride by flowing into the helmet. This feature allows to also
reduce the riding noises (such as wind, motor, track...).
The fit at the bottom of the helmet is extremely important to make the helmet
as quiet as possible. Even with the protective collar, we recommend you wear
a balaclava.
REMOVING THE PROTECTIVE COLLAR
1. 1. 1. 1. Take one side of the protective collar
and pull it out of its fitting (in red).
2. 2. 2. 2. To release the neck pad, pull gently
upward to disengage the plastic strip.
3. 3. 3. 3. Then, pull the 2 notch out of its fitting
nd
on the other side.
4 4 4 4 . . . . The protective collar is also attached on
the chin portion by 4 "arrow snaps". To
fully remove the protective collar, pull
gently on the chin portion, toward the
center of the helmet.
INSTALLING THE PROTECTIVE COLLAR
1. 1. 1. 1. Insert the 4 "arrow snaps" on the chin
plastic strip inside their specific housing.
2. 2. 2. 2. Once the chin plastic strip is in position.
Insert one of the notches located on each
side of the neck pad plastic strip into the
red housing as shown on the picture.
3. 3. 3. 3. Then, insert the plastic strip between
the impact absorbing liner and the shell,
from the one side to the other, by pushing
it inside and backward at the same time
to be able to match the other notch with
the other red housing.
4 4 4 4 . . . . Once it is done and the neck pad
plastic strip is in position, insert the
second notch into its red housing.
WARNING WARNING
WARNING WARNING
Do not carry or hold the helmet by the protective collar. The protective collar
may come off, causing the helmet to drop.
6