Table of Contents
Advertisement
The recovery tank cover gasket (A) ensures the creation of the vacuum in the tank itself and this permits achieving a
perfect vacuum on the squeegee.
The integrity of the gasket is therefore very important for correct machine operation.
To clean and inspect the gasket proceed as follows:
•
Open the cover (A);
Clean the gasket with a rag and make sure it is not cut or damaged;
•
If it is damaged, replace it by removing it from its housing on the cover and fit a new gasket being
•
careful to position the gasket joint in the rear area;
Clean the area of the tank where the gasket rests when the cover is closed.
•
When assembling or replacing the paper filter of the internal vacuum, proceed as follows:
Remove the left side panel by using the proper hook (A);
•
•
Pull the lever to release the internal vacuum;
Remove the filter container;
•
•
Insert the paper filter (B) into the mouthpiece and assemble the container again;
Pull the lever down to lock the vacuum. Close the left side panel.
•
A
MIRAGE Reinigungstechnik
Alt Roggentiner Weg 11, D- 18196 Dummerstorf
CHECKING THE TANK GASKET
FITTING / REPLACING THE BAG FILTER
25
A
www.mirage-reinigungstechnik.de
Telefon: 038208 82560 Fax: 038208 82561 Mobil: 0172 38033
B
Advertisement
Table of Contents
