Table of Contents
Advertisement
Our escalator machine must be operated by properly trained authorised staff.
Escalator cleaners that do not operate properly must be taken out of service immediately.
CHECK BEFORE USE
Make sure to check the following before using the machine:
• Make sure the brushes are in good condition;
• If an internal vacuum is used, make sure that the bag is not full;
• Make sure that the rubber pieces of the brush head are in good condition.
POSITIONING THE MACHINE AND START UP
•
Connect the power cord to the mains;
Position the machine on the escalator landing plate and raise the stand (if it is still lowered);
•
Place the smaller side of the brush head (i.e. the side without the gear box) as close to the side of the escalator
•
as possible;
Activate the brake;
•
Turn on the vacuum and then the brushes;
•
Turn on the escalator and make sure it moves toward the machine.
•
ROTATING THE BRUSH HEAD
•
Unscrew the fixing knob (A) of the brush head;
Rotate the head and tighten the knob;
•
Position the machine on the side of the escalator that remains to be cleaned and repeat the previous operation;
•
At the end of operation remove any dust residues left on the landing plate using the vacuum wand accessory (optional for BASE version).
•
MIRAGE Reinigungstechnik
Alt Roggentiner Weg 11, D- 18196 Dummerstorf
USING THE MACHINE (DRY PHASE)
A
14
Telefon: 038208 82560 Fax: 038208 82561 Mobil: 0172 38033
www.mirage-reinigungstechnik.de
Advertisement
Table of Contents
