Using The Machine (Wet Phase); Positioning The Machine And Start Up; Rotating The Brush Head - Mirage EC52 User Manual

CHECK BEFORE USE
Make sure to check the following before using the machine:
• Make sure the brushes are in good condition and mounted correctly and that the hoses are properly connected;
• Make sure that there is water in the tank and the pipe connection is properly done;
• Check the condition of the rubber pieces of the brush head.

POSITIONING THE MACHINE AND START UP

Connect the power cord to the mains;
•
• Position the machine on the escalator landing plate and raise the stand (if it is still lowered);
•
Place the smaller side of the brush head (i.e. the side where there are no gears) as close to escalator
border as possible;
• Activate the brake;
Turn on the vacuum switch and then the brush switch;
•
• Open the manual tap and then switch on the pump;
Regulate the detergent delivery pressure by setting it between 0.5 and 0.8 bar;
•
Turn the escalator and ensure it is moving towards the machine.
•

ROTATING THE BRUSH HEAD

• Unscrew the fixing knob of the brush head;
• Rotate the head and tighten the knob;
• Position the machine on the side of the escalator that remains to be cleaned and repeat the previous operation;
WASHING THE RISERS WITH THE WAND (optional for the BASE version)
Connect the manual wand to the ESCALATOR CLEANER unit as follows:
• Open the right side panel of the machine;
• Inside the machine, connect the hose A to mouthpiece 4;
• Connect the wand accessory to mouthpiece 4;
• Connect the spiral hose to the quick connector;
• Finally, connect the wand accessory (B) to the spiral hose.
MIRAGE Reinigungstechnik
Alt Roggentiner Weg 11, D- 18196 Dummerstorf

USing the machine (WET PHASE)

b
17
Telefon: 038208 82560 Fax: 038208 82561 Mobil: 0172 38033
www.mirage-reinigungstechnik.de