Table of Contents
Advertisement
The recovery tank must be drained and cleaned after each washing operation.
In order to drain and wash the tank proceed as follows:
•
Turn off the solution pump, brush function and vacuum;
•
Disconnect the power cable from the power mains;
Move to the area dedicated to tank emptying, stopping on a flat section of floor;
•
•
Remove the dirty water tank drain hose (A);
•
Remove the safety cap (B);
Once the tank has been emptied, remove the cover and carefully wash the inside with water.
•
•
Wash well to make sure all residues are removed, even the smallest ones (sand) and also clean the
closing valve well so it is always in good operating condition;
Remove the filter and wash carefully (C).
•
During tank cleaning avoid any water spraying onto the control panel.
B
MIRAGE Reinigungstechnik
Alt Roggentiner Weg 11, D- 18196 Dummerstorf
EMPTYING / CLEANING THE RECOVERY TANK
A
22
C
www.mirage-reinigungstechnik.de
Telefon: 038208 82560 Fax: 038208 82561 Mobil: 0172 38033
Advertisement
Table of Contents
