Handling Fluids And Oil, Fuel Filters; Initial Break-In Maintenance; Maintenance Schedule - Volvo DD29 Operator's Manual

MAINTENANCE INSTRUCTIONS

Handling Fluids and Oil, Fuel Filters

1. When draining fluids, ensure that adequate sealable containers are available
and that every care is taken to prevent spillage.
2. Always ensure that waste fluids are disposed of in an environmentally safe
manner.
3. Always ensure that used filters are stored in secure containers and disposed of
in an environmentally safe manner.

INITIAL BREAK-IN MAINTENANCE

New equipment requires the following initial one time break-in maintenance after 50 hours of
operation. After this initial phase, the regular intervals listed in the following pages should be
followed.
1. Change the engine oil and filter. Refer to Page 5-25 for procedure.

MAINTENANCE SCHEDULE

The maintenance chart (Table 5-1) shows those items that require regular service and the
interval at which service should be performed. A regular service program should be geared to
the items listed under each interval. These intervals are based on average operating
conditions and manufacturer's recommendations. In the event of extremely severe, dusty or
wet operating conditions, more frequent maintenance than specified may be necessary.
Check air cleaner connections and ducts for leaks
Clean/replace air cleaner elements-restrict. indicator
Cleaning the machine
Torque up any loose bolted connections
Check/replace shock mounts torn or severely cracked
Check air cleaner connections and ducts for leaks
Check engine oil level
Check engine coolant, clean radiator/oil cooler
Check air cleaner restriction indicator
Check fuel level
DD-29/31HF/38HF Vibratory Asphalt Compactors
Table 5-1 : Maintenance Schedule
Function
AS REQUIRED
DAILY (OR EVERY 10 HOURS)
Specification
Refer to Section 9 Page 5-5
Page 5-9
Page 5-11
Page 5-12
Page 5-13
Refer to Section 9 Page 5-5
Dipstick marks Page 5-13
Bottle/radiator Page 5-14
Indicator Page 5-15
Level to gauge Page 5-16
SECTION 5
Page
5-3