Table of Contents
Advertisement
OIT***-F113-B12-CB*
OITControl menu structure
9.4.5
OITControl configuration menu > Start-up
Figure 9.34
The current image will be displayed in the left part of the dialog window. The read
ID number will appear on the right side of the dialog window in the ID area, and in
the Read modearea, the read mode can be switched to either direct read or
trigger read. If the trigger-read mode has been selected but the trigger does not
appear, then the button Normal position will lead back to the initial situation. A
complete read operation can be run in the Automaticarea. Here you can setthe
number of seconds after which a new read operation wil start. If no image is
displayed, click on OK to start a read-in of an image. see "OIT system start-up" on
page 42
Dialog box Commissioning OIT system...
71
Advertisement
Table of Contents
