Connecting The Unit - Pepperl+Fuchs OIT F113-B12-CB Series Manual

OIT***-F113-B12-CB*
Installation
The following illustration shows the mounting distance of the code sheets in mm:
Figure 5.4
Note!
Mounting Code Sheets on the OIT300, OIT500, and OIT1500
Ensure that the code sheet is mounted perpendicular to the camera lens in the
OIT system housing. A maximum tilt angle of 10° applies; this angle must not be
exceeded.
5.3

Connecting the unit

Connecting the supply voltage
To connect the OIT system to a voltage supply source, proceed as follows:
1. Plug the Harting HAN Q 8/0 F-connector into its corresponding plug on the
side of the housing.
2. Pull the protective sleeve over the connector until it locks in place.
20
65 mm
OIT200
OIT500
Mounting code sheets
This protects the supply cable from being inadevertently pulled out.
OIT300
OIT1500