Table of Contents
Advertisement
OIT***-F113-B12-CB*
OITControl
Disconnect from OIT system
In order to disconnect an OITControl from an OIT system, proceed as follows:
1. Click
Figure 8.10
2. Click OK.
connection is closed.
8.5
Parameterizing the OIT system
The OIT system is parameterized using an existing Data Matrix code see chapter
6.2.
Note!
User role
In order to program the OIT system; i.e. to change settings in OITControl, log on
as an administrator or primary user in OITControl (Configuration > User
management > Select user).
Open the parameter file
It is possible to load previously stored parameters into OITControl and transfer
them to the OIT system. Proceed as follows:
1. Select Configuration > configure OIT System.
parameter data is yet available:
46
or select File > Disconnect.
The dialog window Disconnect from OIT system... will open:
Disconnect dialog box
The connection to the OIT system is disconnected and the socket
The window invalid parameters... will open saying that no valid
Advertisement
Table of Contents
