Table of Contents
Advertisement
Turning on the power
This section describes how to turn on the power - the Power indicator will
then indicate the status. Please refer to the
section in Chapter 6, Power and Power-Up Modes for more information.
■
After you turn on the power for the first time, do not turn it off until you
have set up the operating system. Please refer to the section
up for the first time
■
Volume cannot be adjusted during Windows Setup.
1. Open the display panel.
2. Slide the Power Button Lock Switch to the right.
3. Press and hold the computer's power button for two or three seconds.
Power button
Starting up for the first time
The Microsoft Windows Vista
displayed when you turn on the power. Follow the on-screen instructions on
each screen in order to properly install the operating system.
When it is displayed, be sure to read the Software License Terms
carefully.
Turning off the power
The power can be turned off in one of three modes, either Shut Down
(Boot) Mode, Hibernation Mode or Sleep Mode.
Shut Down mode (Boot Mode)
When you turn off the power in Shut Down Mode no data will be saved and
the computer will boot to the operating system's main screen the next time
it is turned on.
1. If you have entered data, either save it to the hard disk drive or to other
storage media.
2. Make sure all disk/disc activity has stopped before removing the
CD/DVD or floppy diskette.
User's Manual
for more information.
Power Button
Lock Switch
Figure 1-5 Turning on the power
Monitoring of power condition
®
Startup Screen will be the first screen
Getting Started
Starting
1-7
Advertisement
Table of Contents
