Table of Contents
Advertisement
Problem
Communication is cut
off unexpectedly
A CONNECT display is
quickly replaced by NO
CARRIER
Character display
becomes garbled
during a
communication
You cannot receive an
incoming call
LAN
Problem
Cannot access LAN
Wake-up on LAN does
not work
User's Manual
Procedure
The computer will automatically cut off
communication when connection with the carrier
is not successful for a set time interval - try
lengthening this time interval within your
communication application.
Ensure that the communication application's
error control feature is set correctly.
You are also able to use the AT\N command -
please refer to Appendix C,
further information.
When transmitting data you should ensure that
the parity bit and stop bit settings correspond
with those of the remote computer - you should
check the flow control and communication
protocol settings within your communication
application.
Ensure that the communication application's
rings before auto answer feature is set correctly.
You are also able to use the ATS0 command -
please refer to Appendix D,
information.
If you are still unable to resolve the problem,
contact your reseller, dealer or service provider.
Procedure
Check for a firm cable connection between the
LAN jack and the LAN hub.
Make sure the AC adaptor is connected. The
Wake-up on LAN function consumes power even
when the system is off.
If problems persist, consult your LAN
administrator.
Troubleshooting
AT Commands
for
S-registers
for further
8-23
Advertisement
Table of Contents
