Table of Contents
Advertisement
Installing a memory module (Slot B)
To install a memory module, follow the steps as detailed below:
1. Set the computer to Boot Mode and turn its power off - make sure the
Power indicator is off (refer to the
Chapter 1, Getting Started if required).
2. Remove the AC adaptor and all cables and peripherals connected to
the computer.
3. Close the display panel.
Always make sure the display panel is closed in Laptop mode before
turning the computer upside down.
4. Turn the computer upside down and remove the battery pack (refer to
the
Up Modes, if required).
5. Loosen the screw securing the memory module cover in place - please
note that this screw is attached to the cover in order to prevent it from
being lost.
Use a point size 0 Phillips screwdriver.
6. Slide your fingernail or a thin object under the cover and lift it off.
Memory
module cover
User's Manual
Replacing the battery pack
Screw
Figure 3-15 Removing the memory module cover
Hardware, Utilities and Options
Turning off the power
section in Chapter 6, Power and Power-
section in
3-29
Advertisement
Table of Contents
