Table of Contents
Advertisement
Problem
The "USB WakeUp
function" does not work.
Additional memory module
Please also refer to Chapter 3,
information on installing and removing memory modules.
Problem
If there is a memory
malfunction, the Power
indicator will repeatedly
flash (on for 0.5
seconds, off for 0.5
seconds) in the
following patterns;
If there is an error in
only slot A or no
memory module is
inserted in Slot A:
orange twice, then
green once.
If there is an error in
Slot B: orange once,
then green twice.
If there are errors in
both Slot A and Slot B:
orange twice, then
green twice.
An error will occur if a
memory module is
inserted into Slot B
while no memory
module is inserted in
Slot A.
User's Manual
Procedure
When "USB Sleep and Charge function" is set to
[Enabled] in the BIOS Setup, the "USB WakeUp
function" does not work for ports that support the
USB Sleep and Charge function.
In that case, use an USB port that does not have
the USB Sleep and Charge function-compatible
icon (
) or change the "USB Sleep and
Charge function" setting to [Disabled] in the BIOS
Setup.
Hardware, Utilities and
Procedure
In the event the Power indicator flashes when
the computer is turned on, you should first check
that the installed memory module(s) are
compatible with the computer. If there is an error
with a compatible memory module, there is a
possibility the memory module is damaged.
If you determine that an incompatible module has
been installed, you should follow the steps as
detailed below:
1. Turn off the computer.
2. Disconnect the AC adaptor and all peripheral
devices.
3. Remove the battery pack.
4. Remove the incompatible memory module.
5. Install the battery and/or connect the AC
adaptor.
6. Turn on the computer.
If you are still unable to resolve the problem,
contact your reseller, dealer or service provider.
Remove the memory module from Slot B and
insert it into Slot A.
Troubleshooting
Options, for further
8-19
Advertisement
Table of Contents
