Faults and what to do about them
en
Information on the display panel
Display
Õ
r
E:36
alternating with
-10 and End
when programme is
finished
E:35
alternating with
-10 and End
when programme is
finished (Suitable for
special models)
E (3 ) lights up
Å lights up
The symbol Û
flashes
Other displays
42
Cause/Remedy
Flashes fast + signal: The door was opened and the water level is too high.
■
Close the door, continue the programme with A button or select Spin.
Flashes slowly: The door lock temperature is too high to open the door. Wait
■
approx. 30 seconds until the door lock temperature cools down.
Flashes (no water supply): Tap turned on? Filter in the water supply is
■
blocked?
~ "Filter in the water supply is blocked" on page 40
Is the supply hose kinked or trapped?
Lights up (low water pressure): For information only. This will not affect the
■
programme progress. The programme duration is extended.
The drain pump is blocked.
■
~ "Drain pump is blocked" on page 39
The drain hose at the siphon is blocked.
■
~ "The drain hose at the siphon is blocked" on page 40
There is water in the base trough, the appliance is leaking. Turn off the tap. Call
customer services.
The childproof lock is activated – deactivate it.
Too much foam has been detected and an additional wash cycle has been acti-
vated. Add less detergent to the next washing cycle with the same load.
Run the Drum Clean 60°C programme to clean and care for the drum and the
outer tub.
Notes
Run the programme without laundry.
■
Use washing powder or a detergent containing bleach. To prevent foaming,
■
only use half the amount of detergent recommended by the detergent manu-
facturer. Do not use detergent designed for woollens or delicates.
Switching the information signal on/off.
■
~ "Switching the drum-care information signal on/off" on page 37
Switch off the appliance, wait for five seconds and then switch it on again. If the dis-
play appears again, call customer services.