Appliance Settings; Automatic Switch-Off; Basic Settings - Bosch WAU28540TC Instruction Manual And Installation Instructions

Appliance settings

en
Leave the door and detergent
■
drawer open so that any residual
water can evaporate.
Always wait until the programme
■
ends, as the appliance could still be
locked. Then switch the appliance
on and wait for it to unlock.
Q
Appliance settings
A utomatic switch-off
A p p l i a n c e s e t t i n g s
If the appliance is not operated for a
prolonged period (at least 20 minutes,
depending on the water level inside of
appliance), it will automatically switch
off before the programme starts or after
the programme has ended. Press the
power button # again to switch on the
appliance.

Basic settings

To access the basic settings, touch and
hold the (Silent wash) button for
approx. 3 seconds. You can exit the
setting by touching
button. The control panel show:
You can change the following basic
settings:
The volume of the end signal.
■
The volume of the buttons.
■
The brightness of the Touch-Display.
■
Switching the Drum Clean
■
information signal on/off.
36
(Silent wash)
End signal
You can select position 1 and use the ˜
button to adjust the volume of the end
signal, e.g. '- „.
Possible setting values:
0 off
1 quiet
2 medium
3 loud
4 very loud
Button signal
You can select position 2 and use the ˜
button to adjust the volume of the
button signal, e.g. ›- „.
Possible setting values:
0 off
1 quiet
2 medium
3 loud
4 very loud