Information on the display
panel
Display
YES
NO
¼ flashes
E:17
E:18
E:23
E
9 flashes
Other displays
Faults and what to do about
them.
Faults
Water is leaking out.
No water supply.
Detergent not dispensed.
Washing machine door
cannot be opened.
Cause/remedial action
The washing machine door is unlocked. It is possible to add laundry.
Temperature too high. Wait until the temperature drops.
■
Water level too high. Not possible to add laundry. Close the washing machine
■
door immediately, if open. Select Start/Pause to continue the programme.
Laundry may be caught. Please open and close the washing machine door
■
again and select Start/Pause.
If necessary, push the washing machine door closed or remove the laundry and
■
push it closed again.
If required, switch appliance off and on again; set the programme and make
■
individual settings; start the programme.
Turn the water tap on fully,
■
supply hose kinked or trapped,
■
water pressure too low. Clean the filter. ~ Page 23
■
Detergent solution pump blocked. Clean detergent solution pump.
■
~ Page 22
The drain hose/waste pipe is blocked. Clean the drain hose on the siphon.
■
~ Page 23
Water in the base tub, appliance leaking. Turn off the tap. Call the after-sales ser-
vice.
Childproof lock activated; deactivate it. ~ Page 18
Too much foam detected, a rinse cycle has been switched on ~ Page 19
Switch off appliance, wait five seconds and switch on again. If the display is indi-
cated again, call the after-sales service ~ Page 27
Cause/remedial action
Attach/replace the drainage hose correctly.
■
Tighten the screw connection of the supply hose.
■
Start/Pause not selected?
■
Tap not turned on?
■
Filter blocked? Clean the filter.
■
Supply hose kinked or trapped?
■
Safety function active. Programme stopped?
■
– – – 0 (Rinse hold = without final spin) selected?
■
Can be opened by emergency release only?
■
Faults and what to do about them.
en
25