Table of Contents
Advertisement
If an earth-leakage circuit breaker is
■
used, only a type which displays this
symbol is used: z.
Only this symbol guarantees
compliance with the currently
applicable regulations.
The mains plug can be accessed at
■
all times.
The mains cable is not bent,
■
squashed, modified, cut through, or
in contact with heat sources.
Before washing for the first
time
The appliance was inspected
thoroughly before leaving the factory. To
remove any residual test water, run the
Drum Clean programme the first time
without laundry.
Note:
The appliance must have been
■
installed and connected properly.
~ "Positioning and connecting"
on page 13
Never switch on a damaged
■
appliance.
Insert mains plug.
1.
Turn the water tap on.
2.
Press the # button till the indicator
3.
lamp lights up, release the button.
The appliance is switched on.
Close the door. Do not load any
4.
laundry.
Select the Drum Clean 60°C
5.
programme.
Open the detergent drawer.
6.
Pour approx. 1 litre of water into
7.
dispenser II.
Add standard detergent to
8.
dispenser II according
to manufacturer's instructions for
light soiling.
To prevent over sudsing, use
Note:
only half the recommended amount
of detergent. Do not use any
woollens or mild detergents.
Close the detergent drawer.
9.
Positioning and connecting
Select A.
10.
When the programme ends, press
11.
the # button till the indicator lamp
turns off, release the button.
Your appliance is now ready for use.
Transportation
e.g. when moving home
Preparatory work:
Turn off the water tap.
1.
Reduce the water pressure in the
2.
supply hose. ~ Page 40
Drain any residual water.
3.
~ Page 39
Disconnect the appliance from the
4.
mains.
Remove the hoses.
5.
Empty the dispensers.
6.
~ "Emptying the detergent draw,
cleaning the detergent drawer and
its housing" on page 38 and
Installing the transport locks:
Remove the covers and keep them
1.
in a safe place.
Use a screwdriver if
Note:
necessary.
en
21
Advertisement
Table of Contents
