Faults And What To Do About Them - Bosch WAU28540TC Instruction Manual And Installation Instructions

Faults and what to do about them

Faults
Water is leaking from the
appliance.
The door cannot be
opened.
The appliance is not filling
with water.
Detergent is not being dis-
pensed.
The programme will not
start.
Water is not visible in the
drum.
The water is not draining.
The wrong detergent/fab-
ric softener has been
poured into the dis-
penser(s).
Detergent/fabric softener
has congealed in the dis-
pensers.
Cause/Remedy
Attach the drain hose correctly or replace it.
■
Tighten the screw fitting on the supply hose.
■
Childproof lock activated? Deactivate childproof lock.
■
The temperature in drum is too high to open the door. Wait approx. 30 sec-
■
onds until the temperature in drum cools down.
The safety function is activated. Stop the programme?
■
Can the door only be opened by the emergency release?
■
~ "Emergency release" on page 41
Programme does not start?
■
Is the tap turned on?
■
Could the filter in the water supply be blocked?
■
~ "Filter in the water supply is blocked" on page 40
Is the supply hose kinked or trapped?
■
Have you touched the A button or selected Finish in time?
■
Is the door closed?
■
Childproof lock activated? Deactivate childproof lock.
■
Shop mode activated? If the display shows àœ©˜ for 5 s after you have
■
switched on or off the appliance, the appliance is in shop mode. Turn off
the shop mode as follows:
1. Switch the appliance off and on again.
2. Wait for the display message àœ©˜ to disappear.
Touch and hold A for at least 5 s.
3.
The appliance will automatically switch off. You can use the appliance now
as usual.
Not a fault – the water is below the visible area.
Could the drain pump be blocked?
■
~ "Drain pump is blocked" on page 39
Could the drain hose at the siphon be blocked?
■
~ "The drain hose at the siphon is blocked" on page 40
Empty the dispenser(s), clean it/them and pour in the correct product.
~ "Emptying the detergent draw, cleaning the detergent drawer and its hous-
ing" on page 38
Empty the dispenser(s), clean it/them and pour in the correct product.
Faults and what to do about them
en
43