Table of Contents
Advertisement
Mainboard Installation
IDE Primary/Secondary Master/Slave UDMA
Ultra DMA/33 implementation is possible only if your IDE hard drive supports it and the operating
environment includes a DMA driver (Windows 95 OSR2 or a third-party IDE bus master driver). If your
hard drive and your system software both support Ultra DMA/33, select Auto to enable BIOS support.
The Choice: Auto, Disabled
Init Display First
This item allows you to decide to active PCI Slot or AGP first
The choice: PCI Slot, AGP.
Onboard FDD Controller
This should be enabled if your system has a floppy disk drive (FDD) installed on the system board and you
wish to use it. Even when so equipped, if you add a higher performance controller, you will need to disable
this feature.
The Choice: Enabled, Disabled.
Onboard Serial Port 1/Port 2
This item allows you to determine access onboard serial port 1/port 2 controller with which I/O address.
The Choice: 3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2F8/IRQ3, Disabled, Auto.
UART 2 Mode
This item allows you to determine which Infra Red (IR) function of onboard I/O chip.
The Choice: Standard, ASKIR, HPSIR.
IR Function Duplex
Select the value required by the IR device connected to the IR port. Full-duplex mode permits simultaneous
two-direction transmission. Half-duplex mode permits transmission in one direction only at a time.
The Choice: Half, Full.
RxD, TxD Active
This item allows you to determine the active of RxD, TxD.
The Choice: "Hi, Hi", "Lo, Lo", "Lo, Hi", "Hi, Lo".
Onboard Parallel Port
Select a logical LPT port name and matching address for the physical parallel
(printer) port.
The choice: 378H/IRQ7, 278H/IRQ5, 3BCH/IRQ7, Disabled.
Page 39
Advertisement
Table of Contents
