2.1
Jumpers
2.1.1
Jumper Description
Cards can be configured by setting jumpers. To close a jumper, you connect the pins
with the clip. To open a jumper, you remove the clip. Sometimes a jumper will have
three pins, labeled 1, 2 and 3. In this case you would connect either pins 1 and 2, or
2 and 3.
The jumper settings are schematically depicted in this manual as follows.
A pair of needle-nose pliers may be helpful when working with jumpers. If you have
any doubts about the best hardware configuration for your application, contact your
local distributor or sales representative before you make any changes.Generally, you
simply need a standard cable to make most connections.
Warning! To avoid damaging the computer, always turn off the power supply
before setting jumpers.
2.1.2
Jumper List
Table 2.1: Jumper List
J3
SW1
SW1 & SW2
SW1 & SW2:
2.1.3
Jumper Settings
Table 2.2: J3: LCD Power
Setting
(1-3)*
(3-5)
(3-4)
MIO-2361 User Manual
LCD Power
Auto Power On/LVDS VCON
12V
24V
Function
+3.3V
+5V
+12V
8