Table of Contents
Advertisement
3 - Power ON
1
1. Battery status
Note: The Military ALTITRACK must be switched ON prior to entering the airplane
Press Right or Left Front Button until "ACCESS" and "LOW BAT" flashes. Then release the
button.
The Military ALTITRACK runs a self-test.
The Military ALTITRACK can be used for jumping, if:
- The pointer moves from "6" to "0".
- Battery capacity is sufficient (see paragraph 8)
The Military ALTITRACK MUST NOT be used for jumping, if:
- The LCD on the rear side displays an Error code (ex.: ERR2, ERR3, ERR4, ERR5, ERR100)
- The units sounds a beep every minute.
- Battery capacity is insufficient (see paragraph 8)
When the pointer has detected "0", the Military ALTITRACK performs an automatic testing of the
two barometric sensors (displayed on the OLED).
When the testing is completed the current mBar pressure is displayed for about 4 seconds.
If one of the sensors is defective the OLED shows, "service required". The Military ALTITRACK
can still be used for jumping with only one sensor, however it must be returned for service at the
next opportunity.
8
Advertisement
Table of Contents
