Table of Contents
Advertisement
23 - Military ALTITRACK IrDA Transceiver
23.1 Enable the Military Altitrack IrDA port on the ground
Military Altitrack in Sleep Mode
Press and hold Left Front Button for 3 sec.
The OLED displays "IR Active" and communication is enabled for 2 minutes. During this period
the ALTISET can be used to transmit data.
To disable the IrDa port within 2 minutes, press and hold Left Front Button for 5
23.2 Enable the Military Altitrack IrDA port in the aircraft
Military Altitrack in Jump Mode.
The Military ALTITRACK IrDA port is always active in Jump Mode.
23.3 ALTISET Programming
Press
to activate ALTISET
Adjusting mBar, Backlight and Backlight Intensity
Press
again to select mBar. Press
Press
to go to the next menu point (Backlight)
Press
to select Backlight ON/OFF
Press
to select next menu point (Backlight Intensity)
Press
and then
23.4 ALTISET Data Transmission to Military ALTITRACK
3 seconds. "LINKED" light starts flashing and display shows "Searching for
Press and hold
AltiTrack". The ALTISET is searching for connection with Military ALTITRACK every 4 seconds.
Point ALTISET towards the IrDA transceiver and within 4 seconds the data will be transmitted
and briefly confirmed on the Military ALTITRACK OLED.
The ALTISET will keep searching for IrDA transceivers for 2 minutes each time it has transmitted
data.
ALTISET enters sleep mode if no IrDA transceivers are found within 2 minutes.
or
or
to set Backlight Intensity. Then press
to adjust the mBar. Then press
sec.
42
Advertisement
Table of Contents
