Table of Contents
Advertisement
24 - Replacing ALTISET Batteries
Fig. 41 - ALTISET batteries
When LOW BAT lights, batteries must be replaced.
1. Use Allen Key (enclosed with spare batteries) to remove six Unbrako Socket Screws
from back side of unit
2. Place the ALTISET on a table and carefully remove front cover to expose circuit board
3. Replace batteries and note polarity. Use SANYO 2CR-1/3N (6V) or equivalent
4. Put front cover back into place and fasten screws
5. Use a pencil to press on "RESET" button. The unit restarts
24.1 ALTISET Trouble-shooting
If the ALTISET does not respond when pressing the buttons or if the display shows wrong
symbols, perform RESET.
If the unit does not respond after performing RESET, then replace the batteries
If the unit is still faulty, please contact LARSEN & BRUSGAARD
43
Advertisement
Table of Contents
