Backlight; Battery Status - Larsen & Brusgaard Military ALTITRACK Instruction Manual

7 - Backlight

Enable: Press and hold Right Front Button until "BACKLIGHT ON" and intensity level is displayed
on the OLED.
Disable: Press and hold Right Front Button until "BACKLIGHT ON" and then "BACKLIGHT OFF"
is displayed on the OLED.
Note: The backlight is automatically disabled when manually switching OFF the Military
ALTITRACK.
Adjusting the backlight intensity: When "BACKLIGHT ON" is displayed on the OLED (by
pressing the Right Front Button), click on the Right Front Button again to adjust the backlight
intensity, 1 to 10 (1 = Low, 10 = High).
Note: If the backlight is turned ON while the Military ALTITRACK is not in Jump Mode, the
backlight will automatically turn OFF after 2 hours.
If the backlight is turned ON while the Military ALTITRACK is in Jump Mode, the backlight
will remain ON until the unit exits Jump Mode.

8 - Battery Status

Full capacity: Symbol shows two bars inside the icon.
The Military ALTITRACK can be used without any restrictions.
The two bars correspond to a battery capacity between 100 and 10%
Low capacity: Symbol shows one bar inside the icon.
Replace battery as soon as possible, however the altimeter can still be used for jumping
as long as it is not used for night jumping or at temperatures below zero deg. C.
Very low capacity: Symbol shows no bars inside the icon.
The "Low Bat" light flashes every 15 sec on the altimeter scale.
Do not jump with the altimeter. Replace battery.
Empty battery: The battery icon flashes.
Do not jump with the altimeter. Replace battery.
12