Resetting The Military Altitrack - Larsen & Brusgaard Military ALTITRACK Instruction Manual

16 - Resetting the Military ALTITRACK

The reset button is located inside the battery compartment.
To gain access to the reset button, remove the wrist mount and the battery cover.
Follow step 1 to 5:
Fig. 26
Step 1. Loosen the 4 wrist mount
screws and remove assembly.
Fig. 28
Step 3. Press a paperclip into the tiny (Reset) hole next to the battery and release.
The unit restarts.
Step 4. Put battery cover back into place and fasten the 4 screws. Pay attention that the surfaces
underneath and on the black rubber sealing are clean.
Step 5. Put Wrist Mount assembly back into place and fasten 4 screws.
After resetting, the battery system requires 2 minutes to calibrate itself before displaying the
correct status. While calibrating, the battery icon toggles between full and low.
Note: Reset the unit after battery replacement, when troubleshooting and when verifying software
version number.
Fig. 27
Step 2. Loosen the 4 battery
Cover screws and remove cover
35