IBM TS4300 3555 User Manual page 129

Table 36. Warning events (continued)
Event Code Message Text and Description
4080 Library Verify test failed with warning.
4085 Drive command retries expired.
4086 Move operation failed.
4089 Auto calibration of one or more modules
failed. Adjustment to calibration target
failed.
4090 Auto calibration of one or more modules
failed. Calibration target not found
4091 Auto calibration of one or more modules
failed. Adjustment out of range
Details and Solution
An unidentified failure occurred. Contact your
IBM service representative.
• Run a drive read/write test (Library > Actions
> Tests > Drive test) with a known working
cartridge.
• If the drive test is successful, check in the
host for errors that are related with the
retries.
• If the drive test failed, replace the drive.
• Ensure that the network the library is
connected to is operating normally.
• Ensure that the library is running the current
firmware.
• Restart the library.
• The library must be recalibrated.
• Ensure that the library firmware is up-to-
date.
• This event indicates that one or more of the
gray calibration targets on the library
magazines couldn't be used in calibration.
• Inspect the calibration targets in each
module and then repeat the auto-calibration
routine with the Management GUI.
• The library must be recalibrated.
• Ensure that the library firmware is up-to-
date.
• This event indicates that one or more of the
gray calibration targets on the library
magazines couldn't be used in calibration.
• Inspect the calibration targets in each
module and then repeat the auto-calibration
routine with the Management GUI.
• The library must be recalibrated.
• Ensure that the library firmware is up-to-
date.
• This event indicates that one or more of the
gray calibration targets on the library
magazines couldn't be used in calibration.
• Inspect the calibration targets in each
module and then repeat the auto-calibration
routine with the Management GUI.
Chapter 5. Troubleshooting 99