Administer The Tn799Dp - Avaya MCC1 Hardware Manual

12 Adding New Hardware to Avaya™ MCC1, SCC1, and G600 Media Gateways
Install and Administer IP Connectivity Hardware
NOTE:
To properly seat the circuit pack, push firmly on the front of the faceplate until the latch
reaches the bottom rail of the carrier. Then close the latch until it is fully engaged.
1 Insert the TN799DP circuit packs into the port slots identified earlier.

Administer the TN799DP

Use a terminal emulation application or Avaya Site Administration for the administration.
NOTE:
The customer or design team provides the actual names, IP addresses, subnet masks, and
gateway addresses. Refer to the filled-out job aid titled Pre-Installation Network Planning
Forms—S8700 Media Server for them.
Log in as craft.
1
2 Type list configuration all and press
recognizes the TN799DP circuit packs.
3 Type change node-names and press
4 On page 2, type in the node names and IP addresses for each TN799DP C-LAN circuit
pack.
change node-names ip
csr1clan1
sr1clan2
traf-clan
( 12 of 12
Use 'list node-names' command to see all the administered node-names
Use 'change node-names ip xxx' to change a node-name 'xxx' or add a
node-name
5 Type display circuit-pack and press
Code column.
6 Type change ip-interfaces and press
Name IP Address
192.168.1
172.16 .19 .220
172.16 .19 .118
.
.
.
.
administered node-names were displayed )
to verify that Communication Manager
Enter
.
Enter
IP NODE NAMES
Name
.80
. .
. .
. .
. .
. Verify that the TN799DP shows up in the
Enter
.
Enter
May 2003
Page 1 of 1
IP Address
. . .
. . .
. . .
. . .
. . .
. . .
. . .