Extend/Retract The Extension Platform; Extend/Retract The Extension Platform Manually; Extend/Retract The Extension Platform With The Power Deck; Sj4726) - Skyjack SJ3215 Operation Manual

Section 5 – Operation
5.8 Extend/retract the
extension platform
WARNING
Crush hazard. Do not retract the extension
platform from the ground.
is a risk of death or serious
WARNING
Push the emergency-stop button when you are at
the necessary location or elevation. This prevents
unintended MEWP movement. If you do not obey,
there is a risk of death or
5.8-1 Extend/retract the extension
platform manually
1. Remove the lock-pins
platform.
2. Push or pull the extension handrails to extend or
retract the extension platform.
CAUTION
Install each lock-pin correctly with the detent
ball of each lock-pin fully through the extension
handrails. If you do not obey, there is a risk of
machine damage.
3. Install the lock-pins to lock the extension
platform at the necessary position.
216380ACA
56
If you do not obey, there
injury.
serious injury.
for the extension
1
1
1
5.8-2 Extend/retract the extension
platform with the power deck
(optional equipment for SJ3220 and

SJ4726)

1. Pull the emergency-stop button on the platform
control console.
2. Move the lift/off/drive switch to the lift position.
3. Select and hold the enable switch.
4. Move the extend/retract switch to the extend
position or retract position. Release the switch to
stop.
5. Push the emergency-stop button.
5.9 Electrical inverter (optional
equipment)
1. Turn the main power disconnect switch to the
on position.
NOTE
The LEDs of the inverter show the inverter condition.
A green LED shows operation. If there is a fault, the
status LEDs show the area at fault.
CAUTION
Do not let the power of the MEWP stay on at the
end of the shift. Turn the main power disconnect
switch to the off position. If you do not obey, the
batteries will drain.
SJ3215, SJ3219, SJ3220, SJ3226, SJ4726, SJ4732, SJ4740

Extend/retract the extension platform