1500 W Inverter; Secondary Guarding Lift Enable (Sgle) Push-Button; Elevate™ Telematics - Access Control Unit - Skyjack SJ3215 Operation Manual

Section 3 – Familiarization

3.6-2 1500 W inverter

The inverter changes the DC electrical current to an
AC electrical current from the batteries. The inverter
controls are in the battery tray.
1
2
Status LEDs: These LEDs show the operation or
1
fault of the inverter.
Circuit breaker: If a power overload or positive
2
circuit grounding occurs, the circuit breaker
comes out. Push the circuit breaker into the initial
position to reset the power.
GFCI: This power socket supplies the AC power.
3
NOTE
The inverter operation is automatic. Do not use these
controls for MEWP operation.
216380ACA
30
3.6-3 Secondary Guarding Lift Enable
(SGLE) push-button
3
1
SGLE: This push-button energizes the lift function.
1
Hold the button down together with the function-
enable switch to enable the raising of the platform
with the lift function.
NOTE
The SGLE does not have an effect on these functions:
lower, drive, steer, or emergency lowering.
3.6-4 Elevate™ telematics - access control
unit
Access control is an added function of the Elevate
Trackunit. The access control function does not have
an effect on: emergency-lowering, load sensing, the
horn, and when you lower the platform. These functions
are always available. The access control unit does not
allow the electric motor to operate without an approved
code or card.
IMPORTANT
The owner is responsible to supply PIN codes or
Smart ID cards for MEWPs that have the access
control function. Skyjack does not supply or reset
PIN codes or Smart ID cards. Speak to the MEWP
owner to help you with PIN codes or Smart ID
cards that do not function, or you cannot find.
SJ3215, SJ3219, SJ3220, SJ3226, SJ4726, SJ4732, SJ4740
Optional equipment
™