Stanley Errigal Training Manual page 6

Section 1: Overview
A. Platerack & Splashback Assembly – Part Code: AWPWBCD
The platerack when fitted increases the overall height of the cooker by 20" and provides an
increased plate storage area of 35" (wide) x 11" deep.
If the flue pipe is to be connected to the top outlet connection on the bonnet, the platerack assembly
must be fitted before the flue pipe is fitted to the cooker as shown in Figure 1.2. The platerack &
splashback assembly is fitted using the following procedure (refer to Appendix 2 for Exploded
View & Parts List):
1. Remove the four ¼" round head screws from the hob and loosely fit the LH & RH
standard pieces to the hob using the same screws.
2. Position the Inner Splashback (folded edge to the top) at the back of the Standard pieces
and fasten it loosely to the standards using the 3/16" round head screws & nuts.
3. Insert the towel rail into the front recess on the standard pieces and secure with a No.10
self tapping screw on each side.
4. Place the two slotted rack sections in position ensuring that they rest correctly in the
flange of the splashback and over the towel rail with the end pieces of the rack sections
fitting into the standard at each side.
5. Fit the filler section between the two rack sections and secure in place using the four ¼"
countersunk screws and nuts.
6. Tighten up all the screws and bolts to ensure that the unit is rigid.
7. Fit the outer splashback to the inner splashback using the four No.10 self tapping
screws.
B. Warming Shelf – Part Code: 1590011
The warming shelf allows for an increase in the hob area of approximately 8.5" on each side of the
cooker with the shelf spanning the depth of the hob. The warming shelf comes as a standard
assembly which can be fitted to either side of the cooker as required and it is fitted using the
following procedure (refer to Appendix 3 for Exploded View & Parts List):
1. Remove the two ¼" round head screws from the side of the hob and the two ¼" round
head screws from the side of the front frame.
2. Fix the bracket to the warming shelf using the ¼" x 1" hex head bolt and 3/8" washer.
3. Loosely fit the warming shelf assembly to the hob using the two ¼" x ¾" hex head bolts
and to the front using the ¼" round head screw.
Figure 1.4
Page 3