Stanley Errigal Training Manual page 26

Section 4: Part Replacement Procedures Page 23
Figure 4.10
F. Side Panel Replacement
Remove the outer back sheet iron (77) by removing the four self tapping screws (two
on each side) to allow access to the side panel fixing screws (one on each side)
located on the back edge of the side panel (65/66). Having removed the side panel
fixing screw, the side panel is removed by levering it out at the bottom to allow it to
be retracted from the front casting. When refitting the side panel ensure that the front
edge is flush with the back of the front casting (1) and the top edge is level with the
underside of the hob casting (18).