Stanley Errigal Training Manual page 24

Section 4: Part Replacement Procedures
C. Replacement of Cast Iron Liners
The following procedure should be used to remove and replace the cast iron firebox
liners:
1. Lift up the bottom front fire lining (48) to remove it as shown in Figure 4.5.
2. Unscrew the ¼" x 1 ¾ " Counter Sunk fixing screw (see Figure 4.6) holding
on the Top Front Fire Lining (49) and move the lining towards the centre of
the firebox to remove same. It may be necessary to remove or loosen excess
fire cement from the RHS of the lining.
3. Pull the front edge of the LH Fire Lining (46) to the RHS of the firebox to
allow for removal of the Back Fire Lining (47) – see Figure 4.7.
4. Remove the LH Fire Lining (46) through the fire door opening and then
remove the RH fire Lining (44) through the same opening.
5. With the RH Fire Lining (44) removed, the Oven Protecting Plate (45) can be
removed from the lining by loosening the two ¼" x ½" Countersunk screws –
see Figure 4.8.
6. Reverse steps 1 -5 to refit the fire linings.
Figure 4.5
Figure 4.7
Page 21
Figure 4.6
Figure 4.8