Stanley Errigal Training Manual page 25

Section 4: Part Replacement Procedures
D. Hob Replacement
If the cooker is connected to the chimney system using the top flue configuration, it
will be necessary to disconnect the flue system and bonnet (55) before removing the
hob using the following procedure:
1. Remove all the loose parts from the top of the hob i.e. Oblong Hotplate (19),
Hot Ring (20) and Hob Cleaning Cups (15).
2. Remove the four hob fixing screw caps to allow for access to remove the four
hob fixing screws (see Figure 4.9).
3. Remove the Hob casting (18) by tapping the front edge upwards to break the
cement seals.
4. To reassemble, reverse the above procedure ensuring that all fire cement is
removed from any of the cement joints before new cement is applied.
E. Front Replacement
To allow for removal of the front casting (1), the hob casting (18) must be removed as
described previously and then the following procedure should be used:
1. Remove the three doors by lifting them off the hinge blocks and lift off the
cleaning door (59).
2. Remove the towel rail (78) and towel rail brackets (25 & 26) by loosening the
two fixing screws on each bracket.
3. Remove the two ¼" x 1" countersunk fixing screws as shown in Figure 4.10.
4. Remove the front casting (1) by tapping the forwards to break the cement
seals.
5. To reassemble, reverse the above procedure ensuring that all fire cement is
removed from any of the cement joints before new cement is applied.
Figure 4.9
Page 22