16.3.5. Controller reconfi guration required to manage external fi lter module FB-CA HE or FBL-HE
17. RESET THE CORRIGO CONTROLLER
In some cases, after several adjustments or due to a bad working, it could be necessary to reset the
controller. After isolating the unit and switching-off the main switch, open the door which gives access
to the electronic board. Remove all the connectors attached to the controller with the exception of the
4-way electrical supply green plug connected to terminals 1,2, Earth and 4.
Ext.
Disp.
With a screwdriver, release the controller from the DIN rail on which it is mounted.
To reset the controller, it must be under voltage so re-energise the CADB/T-HE at the isolator and also
on the unit by switching back on the main switch.
TCP / IP
52
Ext.
Disp.
TCP / IP