HP ProCurve 8000M Installation Manual page 9

6. Reinstall the Management module into its slot and the network
modules into their previous positions in slots A and B. (Make sure
you do not overtighten the screws on the modules.)
7. Reinstall the network cables. If you disconnected the network cables in step
2, reconnect the cables to the correct ports on the network modules.
8. Reinstall the power supplies and cover plates. On the back of the switch,
reinstall the power supply or supplies, and cover plates.
Lower the power supply into
the opening and push it all the
way back until it connects with
the switch power connector.
Caution: Make sure that AC power is disconnected from the power
supply before installing the power supply into the switch.
9. Reconnect the AC power to the power supplies.
9