Replacing An Air Filter - Huawei Telecom Power TP48200A-DX12A1 User Manual

TP48200A-DX12A1 Telecom Power
User Manual
4.
Step 2 Disconnect the interconnection terminal from the fan power cable.
Step 3 Record the fan installation direction and remove the fan, as shown in the following figure.
Figure 4-12 Removing a fan
Step 4 Install the new fan according to the fan installation direction you recorded.
Step 5 Reconnect the interconnection terminal to the fan power cable.
Step 6 Reinstall the UIM02C.
1.
2.
3.
4.
----End

4.4.8 Replacing an Air Filter

Prerequisites


Issue 07 (2019-11-15)
Disconnect the 48 V power cable from the UIM02C, as shown in Figure 2.
Connect the 48 V power cable to the UIM02C.
Insert the UIM02C into the correct slot, and tighten the screws.
Reconnect the signal cables to the UIM02C based on the recorded information.
Disconnect the ground cable from the ESD wrist strap, and take off the ESD wrist strap
and ESD gloves.
You have obtained the cabinet door key and tools.
The new air filter is intact.
Copyright © Huawei Technologies Co., Ltd.
4 Maintenance
49