Annual Maintenance Requirements; Pre-Installation Instructions - Pentair 1.0 Service Manual

PRODUCT NAME
Pentair Acid Neutralizing System 1.0
Pentair Acid Neutralizing System 1.5
Table 2 -- Order Number for the replacement media
Product Name
Acid Neutralizer
• Do not install this system where water is microbiologically unsafe or of unknown quality without
adequate disinfection before or after the system.
• This system must be installed in an area that is not affected by extreme heat, cold or the elements.
The selected installation area must be adequate for easy service of all parts.
• This system must be installed in accordance with all applicable state and local laws and regulations.
• This system is designed to treat cold water only and can be installed on any cold water supply.

ANNUAL MAINTENANCE REQUIREMENTS

• Clean the backwash flow control.
• Verify that the flow meter is functioning correctly. Clean the impeller, if necessary.
• Verify the programming of the control. Reprogram, if necessary.
• Verify the minimum and maximum water pressure. Install a pressure reducer, if necessary.
Additional Annual Maintenance Requirement For Acid Neutralizers:
• Check the height of the filter bed by measuring the distance from the top of the tank to the top
of the filter media. Add neutralizing media as needed to reach the desired height. It is normal
for the media to be consumed as part of the neutralizing process. Depending on pH of
incoming water and usage, you may need to add media more or less frequently.
4
Table 1 -- Filter Data Chart
MEDIA AMOUNT
1.0 cuft
1.5 cuft
Replacement Media
Calcium Carbonate (90lbs./cu.ft)

PRE-INSTALLATION INSTRUCTIONS

A
SERVICE FLOW
TANK
RATE
( DIAMETER X HEIGHT)
10 X 44 6.0 gpm
10 X 54 7.0 gpm
Neutralizer
TANK SIZE
10 X 44
10 X 54
DRAIN FLOW
RATE
6.0 gpm
6.0 gpm
Order Number
14829
Dimension "A"
when full ( inch )
15 ~ 17
14 ~ 16