Pentair 1.0 Service Manual page 12

7. CYCLE 3 - FAST RINSE/BRINE REFILL
The control will display:
FILL/RNS: 3 min
• Press the UP or DOWN ARROW to change the length of the fast rinse. The setting range is 0 to 99
minutes (maximum limit). Note: In most applications, this setting will not need adjusting.
Press the SCROLL BUTTON to advance to the next setting.
To Exit Press Down Arrow
Press the DOWN ARROW to exit the Installer's Level.
Note: If you need to recheck settings or make a change, pressing SCROLL when "EXIT" is
displayed will take you back to the start of Installer Settings.
IMPORTANT NOTE: TO ACTIVATE THE NEW SETTINGS, YOU MUST EXECUTE A COMPLETE
REGENERATION. IF YOU DO NOT MANUALLY REGENERATE THE SYSTEM, THE SETTINGS WILL
NOT BECOME ACTIVE UNTIL THE UNIT HAS COMPLETED THE NEXT SCHEDULED REGENERA-
TION.
HOW TO PROGRAM THE END USER'S LEVEL
To begin, verify that the control is in the Service Mode.
Time of Day GL Remaining
Press the SCROLL BUTTON to advance to the next setting.
The following settings are available in the End User's Level:
1. TIME OF DAY
The control will display:
Set Time of Day
• Press the UP or DOWN ARROW to program the time of day.
Press the SCROLL BUTTON to advance to the next setting.
2. IMMEDIATE REGENERATION MODE
The control will display:
Regen in 10 sec
• If the control is left in this position, the timer will countdown from 10 to 0, initiating a regeneration at
0.
• To avoid an immediate regeneration, press the SCROLL BUTTON before the timer reaches 0.
Press the SCROLL BUTTON to advance to the next setting.
3. DELAYED REGENERATION MODE
The control will display:
Regen @ (1 am)
• If the control is left in this position, the unit will regenerate at the programmed time. The display will
remain in the Delayed Regeneration Mode until the regeneration has begun.
• To cancel the Delayed Regeneration Mode, press the SCROLL BUTTON.
Press the SCROLL BUTTON to return to the Service Mode.
12