Setting Up The Cartridge - Prolitec AirQ 380 Original Instructions Manual

Setting Up the Cartridge

1. Use the key to unlock and open the door.
2. Prepare the cartridge.
• Remove the plug from the TOP port (b) of the cartridge
• Remove the big plug from the air-intake port (a) on the flat surface (back side) of the top of
the cartridge.
(c) Front Output Port
NOTE for Wall-mounted and table-top installations:
FRONT Output Port MUST REMAIN PLUGGED for the cartridge to
operate in wall-mounted installations. Use the Top Output Port with
the plastic extension tube that comes with the unit, to deliver the
fragrance. You must use this tube when pluming out of the top.
NOTE for Track Light mounted installations:
Use the Front Output Port WITHOUT ANY TUBING. The TOP
Output Port MUST REMAIN PLUGGED for the cartridge to operate
in track light-mounted installations. If use of the front output
port creates condensation on the door, then switch to the Top
Output Port. See the section about Track Light-Mounted cartridge
concerns.
AirQ 380/580 OPERATING INSTRUCTIONS
7
(b) Top Output Port
(a) Air Intake Port
24