Replacing The Et 200Pro Fc-2 - Siemens SIMATIC ET 200pro FC-2 Operating Instructions Manual

Repair

9.1 Replacing the ET 200pro FC-2

Recycling and disposal
For environmentally-friendly recycling and disposal of your old device, please contact a
company certified for the disposal of waste electrical and electronic equipment, and dispose
of the old device as prescribed in the respective country of use.
9.1 Replacing the ET 200pro FC-2
Replacing the converter
If the converter requires to be replaced, due to a persistent fault condition, then the
procedures outline below should be performed.
Unexpected drive behaviour by unsuitable converter settings
The converter should be replaced with another converter with the same firmware version of
the converter being replaced.
If the firmware versions are different, it is possible that the converter will not respond in
exactly the same manner as the old converter. This could result in unexpected behaviour of
the replacement converter.
• If the firmware version of the replacement converter is different, then you have to
208
WARNING
recommission the converter from the default factory settings.
Operating Instructions, 04/2018, FW V4.7 SP10, A5E34257324B AF
SIMATIC ET 200pro FC-2 converter