External Bypass Valve - Zenith HydroTap G4 Celsius Series Installation Instructions Manual

Note:
Before you install a unit, determine whether a water softener or an external filter is required.
6.3
E
xternal Bypass Valve (B160 and B240 models)
The diverter bypass valve allows the user to choose to have the boiling feed water bypass the internal filter and
only be filtered by the external filtration. This diverter valve is located at the rear panel of the undersink unit on
the filter door side, see the image below.
Check the table below to determine which filter bypass position you need for your product.
If no external fi lter is installed, select position A
A
2
Hose and tube fitting. (Do not overtighten)
• Remove all caps from the top of the undersink unit.
• Fit the foam insulation to the Blue tube after trimming to length.
• Install the mains water braided hoses to the undersink unit before locating the unit in place.
Page 24 of 32
Installation
1 NO EXTERNAL
FILTER INSTALLED
SELECT POSITION A
A
2 4
3
B
1
EXTERNAL
FILTER INSTALLED
SELECT POSITION B
2 4
3
PN: 801231
1
4
Rotate 90°
only
3
If an external filter is installed, select position B
802700NZ - Commercial Installation Instructions - Aug 2015 - V2.01
B
Rotate 90°
only
1
2
4
3