Transportation, Storage And Disposal - Husqvarna AUTOMOWER 105 Operator's Manual

Robotic lawn mowers
Hide thumbs Also See for AUTOMOWER 105:
Table of Contents

Advertisement

Available languages

Available languages

6.1.1 Indicator lamp in the charging station
For a fully functional installation, the indicator lamp in the charging station must emit a solid or
flashing green light. If something else appears, follow the troubleshooting guide below.
There is more help on www.husqvarna.com. If you still need help, please contact your local
Husqvarna representative.
Light
Cause
Green solid light
Good signals
Green flashing
The signals are good and
light
is activated.
Blue flashing light The boundary loop is not connected
to the charging station.
Break in the boundary loop.
Red flashing light Interruption in the charging station's
antenna.
Red solid light
Fault in the circuit board or incorrect
power supply in the charging station.
The fault should be rectified by an
authorized service technician.

7 Transportation, storage and disposal

7.1 Transportation
The supplied Li-ion batteries obey the
Dangerous Goods Legislation requirements.
Obey all applicable national regulations.
Obey the special requirement on package
and labels for commercial transportations,
including by third parties and forwarding
agents.
For how to remove the battery, refer to
the complete Operator's manual on
www.husqvarna.com.
7.1.1 How to lift and move the product
To safely move from or within the work area:
1.
Push the STOP button to stop the
product. If security is set to the medium or
high level the PIN code has to be entered.
24 - Transportation, storage and disposal
Action
No action required
ECO mode
No action required.
Check that the boundary wire con-
nectors are fitted properly to the
charging station.
Find out where the break is. Replace
the damaged section of the loop with
a new loop wire, and splice using an
original coupler.
Contact your local Husqvarna repre-
sentative.
Contact your local Husqvarna repre-
sentative.
The PIN code contains four digits and is
selected when you start the product for
the first time. Refer to complete
Operator's manual.
2.
Switch off the product with the main
switch or the ON/OFF button.
1418 - 002 -

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents