Transport And Installation - Promac SX-818DV Operating Instructions Manual

Cutting capacity +45°
Cutting capacity +60°
4.2 Noise emission
Acoustic pressure level (EN 11202):
Idling
Operating
The specified values are emission levels and are not
necessarily to be seen as safe operating levels.
As workplace conditions vary, this information is intended
to allow the user to make a better estimation of the
hazards and risks involved only.
4.3 Features
This machine is suitable for cutting normal steel, steel
pipes and tubes while permitting cutting angles of +60
degrees and +45 degrees thanks to the pivoting cutting
head.
An overview of the tooth options is shown on the machine
as a reference for cutting purposes.
The variable speed control permits the convenient
selection of speeds. This machine is equipped as
standard with a smooth adjusting DC motor.
This machine permits manual cutting in that the saw bow
can be pulled down by hand. The start button is located
on the handle of the saw bow. The motor stops when the
button is released.
The stability of the machine including the work bench
height amounts to 950 mm and complies with standard
technical practice.
The 20 mm saw band and hard metal guide produce
enhanced results in terms of the cutting surface and
efficiency.
The single-part cast design and unique CNC processing
offer enhanced machine rigidity and precision.
The single-part full band cover complies with the relevant
CE standards. The coolant system keeps the work area
clean and dry while guaranteeing its safe nature.
The catch tray under the worktop prevents coolant
leakage on to the floor thus keeping it dry.
Coolant for cutting:
water: oil = 40: 1 oil specification.

5. Transport and Installation

5.1 Unpacking
Please use a fork-lift truck for transporting the equipment
to the required location prior to unpacking. (fig. A)
For transport purposes after unpacking, please use a
fibre belt for heavy loads when lifting the machine.
○110 mm
□110 mm
○70 mm
□70 mm
Lpa 71,0 dB(A)
Lpa 83,8 dB(A)
5.2 Machine transport
As this machine weighs 208 kg, you are advised to use a
suitable aid when transporting the machine.
Recommendations for transport purposes:
1. Tighten up all locking devices prior to the transport.
2. Keep a secure stance and steady balance at all times
when transporting the machine, and only use a durable fibre
belt for heavy loads when lifting the machine as shown in fig.
B.
3. SWITCH the power supply OFF prior to wiring and ensure
that the machine is properly earthed. Overload and protective
switches are recommended for safety wiring purposes.
4. Fasten the 4 screws in the plinth holes indicated once the
machine has a secure stance.
5. Check carefully whether the saw band runs in an
anticlockwise direction. If not, reverse the wiring shown in the
wiring plan and then repeat the test.
6. Do not expose the machine to sunlight, dust, moisture or
rain at any time.
Fig A