Use Of The Most Important Mashine Parts - Promac SX-818DV Operating Instructions Manual

Metal band saw
Table of Contents

Advertisement

Available languages

Available languages

5.3 Assembly/Installation
Keep a secure stance and steady balance at all times
when transporting this 208 kg machine.. Lift the machine
off the floor, remove the 4 flanges and assemble it on the
base. Fasten the machine on to the base and lock the
connecting wedge element.
Remove the wooden box fully from the machine.
Disengage the machine from the floor of the box.
Position and fasten the 4 screws properly in the plinth
holes once the machine has a secure stance.
Switch the power supply off prior to wiring and ensure
that the machine is properly earthed. Overload and
protective switches are recommended for safety wiring
purposes.
Do not expose the machine to sunlight, dust, moisture or
rain at any time.
Fig B
5.4. Cleaning & lubrication
(1) The equipment is coated with a heavy lubricant to protect
it when being transported. This coating is to be removed
completely prior to the initial operation of the machine.
Commercial degreasing agents, kerosene or similar solvents
can be used to remove the lubricant from the machine, but
solvents must be prevented from coming into contact with the
bands or other rubber parts.
(2) Coat all bright parts with a light lubricant after cleaning.
Coat all tips with machine oil of a medium consistency.
6. Use of the most important machine parts
6.1 Power systems and control fitting
The electric output of your band saw is controlled
magnetically either via 230 volt alternating current or 400 volt
3-phase current.
Before connecting the machine to the mains supply ensure
that the motor shaft is running in the right direction.
We advise you to use mains cable measuring 1,5 mm ²
protected with 10 ampere dual-element fine fusing for the
power supply to all machines irrespective of their electric
output.
Consult the electric wiring plan supplied with the machine for
further instructions concerning the question as to how the
saw is connected to a power source. The power supply must
be disconnected when the band cover is opened or used
during repair.

Advertisement

Table of Contents
loading

Table of Contents