Lennox M0STAT64Q-1 Installation & Operation Instructions page 6

2. Select the cable exit route from the back of the
controller. See figure 8.
1
PCB
1
2
PCB
Figure 8. Select Cable Route
3. Include a drip loop in the cable. See figure 9.
4. Seal the cable entrance to the controller cas-
ing and any wall penetrations to prevent water
from entering the controller. See figure 9.
Sealant
Drip
Loop
Figure 9. Prevent Water from Entering Con-
troller Casing
3
1
PCB
¹Use snips to notch the
controller casing to allow
the cable to pass through.
Sealant
Sealant
Drip
Drip
Loop
Loop
5. Reattach the controller to the back plate. Be
careful not to pinch or bind the wires. See fig-
ure 10.
Figure 10. Reattach Controller to Back Plate
6