Sun Microsystems Sun Ultra 27 Operating System Installation Manual page 34

Installing the Solaris Operating System From a JumpStart Server
The network card boots and after receiving the correct response from the DHCP server,
displays the Boot Agent message similar to:
Intel(R) Boot Agent PXE Base Code (PXE-2.1 build 0.86)
Copyright(C) 1997-2007, Intel Corporation
CLIENT MAC ADDR 00 14 4F 29 04 12 GUID FF2000008 FFFF FFFF FFFF 7BDA264F1400
CLIENT IP: 10.6.68.29
GATEWAY: 10.6.68.1
When prompted, press F12 for a network service boot.
4
The PXE image menu will be displayed if there is more than one image available.
Select the Solaris image to install, if multiple are listed, and press Enter.
5
The operating system is installed and the workstation reboots when it is complete.
6
The following are the log files for the JumpStart installation:
/var/sadm/system/logs/install_log
Install drivers as described in
7
configured to preload the drivers.
34 Sun Ultra 27 Workstation Linux, OpenSolaris and Solaris Operating System Installation Guide • August 2009,
Revision A
MASK: 255.255.255.0
begin_log
finish_log
sysidtool.log
"Installing Drivers"on page
DHCP IP: 10.6.68.49
20, unless your JumpStart image is